Auto Pedals Firmware updater - MacOs

FIRMWARE UPDATE

! SPECIAL PROCEDURE FOR SERIAL IDs BELOW 415 !

Pedals with serial numbers below 415 (manufactured until Feb. 2025, aka 02/25) require the AUTO M-Type USB MIDI driver for firmware updates and macOS USB-MIDI detection. Check your AUTO Series pedal’s serial number on the button surface before proceeding.

The update can be executed through the following web browsers: Google Chrome, and Mozilla Firefox

The update CAN NOT be executed through the following web browsers as they do not support Web MIDI: Safari, Microsoft Edge, Brave, Opera

Download the driver using the link below and follow the instructions here How_to_Install_Driver.pdf.

MacOs Driver for devices with M processors

MacOs Driver for devices with Intel processors

Pedals from later batches (manufactured from 03/25) do not need this driver on macOS.

PREPARE

First, prepare a suitable 9V DC center-negative power supply with at least 250 mA or higher. Daisy-chain power solutions are not recommended.
Then, close any applications that may be using MIDI, such as DAWs or other MIDI controllers.
And have a USB-C cable ready to connect your AUTO M-Type pedal to your computer.

CONNECT

Connect your AUTO Series pedal to a suitable power supply while holding both footswitches.
The dynamic LED bar will show a rolling animation, confirming that the pedal has entered firmware update mode.
Use a USB-C cable to connect the AUTO Series pedal to your computer.
Your computer’s operating system may (and may not, no worries about that) notify you that a new MIDI device - your AUTO Pedal - has been connected.
And depending on your browser, check if any pop-ups are asking you to enable the MIDI sysex messages.
You can find the full update instrucion in the README.pdf file.

Select Firmware Version:

Show Firmware changelog

FIRMWARE UPDATE

PREPARE

CONNECT

Select Firmware Version:

USEFUL INFORMATION

CONTACT US

NEWS AND SUBSCRIBER DEALS

News and Subscriber-only deals